Configuration and set-up of Nimly Door lock

Setting the master code

This is a unique programming code used only for manual registration of codes, changing functions, and other settings. The factory code is 123, and all codes can contain up to 8 digits. We recommend using at least 6 digits for increased security.

To set the first master code, follow these steps:

1. Press *
2. Enter user ID (000)
3. Enter factory code (123)
4. Press *
5. Enter the new master code (up to 8 digits)
6. Press *
7. Enter the new master code again to confirm.

Example

Please note that this example uses a commonly used code "123456" for illustration purposes only. Do not use this code as your actual master code.

To set the first master code to "123456":

1. Press *
2. Enter user ID 000
3. Enter factory code 123
4. Press *
5. Enter the new master code 123456
6. Press *
7. Enter the new master code again 123456
8. The keyboard will beep to confirm that the new master code has been accepted.

Registering user code

To add a new user code, follow these steps:

1. Press *
2. Enter user ID (003-999)
3. Enter the master code followed by *
4. Enter the new user code (up to 8 digits) followed by *
5. Enter the new user code again to confirm, followed by *

Example:

To add a new user code with user ID 003 and new user code 2323, follow these steps:

1. Press *
2. Enter user ID (003)
3. Enter the master code followed by *
4. Enter the new user code (2323) followed by *
5. Enter the new user code again to confirm (2323), followed by *
6. The keyboard will confirm successful registration with a quick green flash and beep. A red flash indicates that the input was unsuccessful. You may have taken too long.

Deleting user code

To delete a unique user code, you need to know the user ID where the code was first registered. The sequence is confirmed with a beep.

1. Press *
2. Enter user ID (003-999)
3. Enter the master code followed by #

Example:

To delete user code with user ID 003:

1. Press *
2. Enter user ID (003)
3. Enter the master code followed by #

Registering access card/tag

To add an access card, follow these steps:

1. Press #
2. Press 8
3. Enter user ID (000-999)
4. Enter the master code followed by #
5. Place the access card next to the lock (external unit)
6. The keypad will confirm successful registration with a quick green flash and beep. A red flash indicates that the input was unsuccessful. You may have taken too long.

Example:

To add an access card with user ID 005:

1. Press #
2. Press 8
3. Enter user ID 005
4. Enter the master code followed by #
5. Place the access card next to the lock

Deleting access card

If a unique access card is to be deleted, you need to know which user position the card was first registered on. The sequence is confirmed by a green flash and beep.

Follow these steps:

1. Press #
2. Press 9
3. Enter the user ID for the unit to be deleted (000-999)
4. Enter the master code followed by #

Example:

To delete an access card with user ID 005:

1. Press #
2. Press 9
3. Enter user ID 005
4. Enter the master code followed by #